Samsung S42SD - YD04 Plasma Screen Diagnosis and Maintenance Guide First, understanding the function of each module on the screen: As shown below, the PDP screen consists of several key components such as the power board, X driver board, Y driver board, logic board, logic buffer board (E, F, G), Y buffer board (upper and lower), and COF: - Power Board: Provides power to the screen and other modules, including the motherboard from the system manufacturer. - X Driver Board: Generates and supplies driving signals to the X electrode based on timing signals from the logic board. - Y Driver Board: Generates and supplies driving signals to the Y electrode according to timing signals from the logic board. - Logic Board: Processes image signals from the main board, generates addressing drive signals, and provides signals for the X and Y driver boards. - Logic Buffer Board (E, F): Converts data and control signals from the logic board into signals required by the COF. - Y Buffer Board (Upper and Lower): Transmits scanning signals from the Y driver board to the screen, divided into upper and lower sections. - COF: Converts signals from the logic buffer board into address signals used by the screen. Second, fault diagnosis: 1. The screen does not light up: a. Check if the socket connecting the power supply filter board to the power board is properly plugged in. If not, reinsert it. b. Inspect the fuse on the power board. If it's blown, replace it with a new one. c. Ground pin 4 of the CN802 socket on the power board. Then set the toggle switch SW2001 on the logic board to internal mode (1, 3, 2, 4) from the original external mode (1, 2, 4, 3). Turn on the power and check if the screen lights up. If it displays a normal full white field signal, further checks may be needed for the motherboard or video processing board. d. If the screen still doesn't light up, try replacing the power board. e. If the issue persists after replacing the power board, consider replacing the entire screen. 2. One or several horizontal lines appear on the screen: Check if the socket between the Y driver board and Y buffer is connected. If not, reinsert it. If it is connected, and dark lines appear at the top or bottom, replace both the upper and lower Y buffer boards. 3. One or several bright horizontal lines that are brighter than the rest: Follow the same steps as above. If the issue remains, replace the Y buffer boards. 4. A vertical unlit line or block appears on the screen: a. If the line is not lit, the problem may be with the COF. b. If there's a vertical non-lit block, first check the connection between the COF and the logic buffer. If that's fine, check the connection between the logic buffer and the logic board. If all connections are good, replace the logic buffer. If the issue still exists, replace the logic board. 5. When a monochrome signal is displayed, some vertical bright lines or blocks appear: a. Vertical bright lines or blocks may indicate a faulty COF or screen. b. For vertical bright color blocks, check the connection between the COF and the logic buffer. If no issues, check the connection between the logic buffer and the logic board. If still problematic, replace the logic buffer. If the problem remains, replace the logic board. If the issue persists, the COF may be faulty. 6. Abnormal highlights or bright blocks appear on the screen: a. Check the connections between the logic board, logic buffer board, and COF board. b. Replace the logic buffer board and logic board if necessary. If the problem continues, the COF may be the cause.
PP PE Rigid Plastic Pelletizing Line
Pp Pe Rigid Plastic Pelletizing Line,Pelletizing Line For Pp Pe Rigid Plastic,Pp Pe Rigid Plastic Pelletizing Machine,Pp Pe Rigid Plastic Pelletizing System
Zhejiang IET Intelligent Equipment Manufacturing Co.,Ltd , https://www.ietmachinery.com