This article introduces the design of an intelligent electronic scale system based on the AT89S52 microcontroller. The AT89S52 is an 8-bit single-chip microcomputer that uses FLASH ROM technology for on-chip memory. It is fully compatible with the MCS-51 series and can operate at ultra-low voltages as low as 3V, with a maximum crystal frequency of 24MHz. The chip is packaged in a standard 40-pin DIP format and features four 8-bit bidirectional I/O ports: P0, P1, P2, and P3.
The 31st pin must be connected to a high voltage to enable the internal program memory, while the 9th pin serves as the reset pin, typically connected to a manual reset circuit. The 40th pin is VCC, connected to +5V, and the 20th pin is GND. A 0.1μF high-frequency capacitor is usually placed between VCC and GND for filtering. A 12MHz crystal oscillator is connected between pins 18 and 19 to provide a stable clock signal for the microcontroller.
Each pin of the AT89S52 has specific functions. For example, VCC is the power supply, while GND is the ground. Port P0 is an open-drain I/O port that can drive up to 8 TTL gates when used as an output. When accessing external memory, it can also act as an address/data bus. Port P1, P2, and P3 are all bidirectional I/O ports with internal pull-up resistors, allowing them to function as inputs or outputs.
Port P3 is unique because it supports multiple special functions, such as serial communication, external interrupts, and timer control. These functions are often used in applications like data transmission and sensor interfacing. The RST pin is used for resetting the microcontroller, while ALE/PROG provides address latching during memory access or programming. PSEN is used to read from external program memory, and EA/VPP controls whether the microcontroller uses internal or external program memory.
XTAL1 and XTAL2 are the input and output pins of the internal oscillator, essential for generating the system clock. Understanding these pin functions is crucial for designing and debugging systems using the AT89S52 microcontroller. With its flexibility and wide range of features, the AT89S52 is a popular choice for embedded systems, including intelligent weighing systems.
Film Overcoated With F46 Copper Flat Wire
|
About Film Overcoated With F46 Copper Flat Wire
|
Polyimide-F46 combined film wrapped sintered copper flat magnet wire insulation wire
This product provides high heat resistance, high cut through, solvent resistance, radiation resistance, cold resistance, freon resistance , etc .
The technical indexes for aluminium core enameled wire comply with enterprise standards extablished in reference to national standards .
Inner packing: in different wooden bobbin ,
Outer packing:wooden pallet with steel strip or according customers' special requirements
Film Wrapped Copper Wire,Film Overcoated With F46 Copper Flat Wire,F46 Copper Flat Wire,Film Covered With F46 Copper Flat Wire
HENAN HUAYANG ELECTRICAL TECHNOLOGY GROUP CO.,LTD , https://www.huaonwire.com